ProductsOther

  • Product Name:

    Taiwan Shijun ACECO FC1001 Handheld Portable Frequency

  • Categories:Other / Power Meter
  • Date:2012-09-19
  • Taiwan Shijun ACECO FC1001 Handheld Portable Frequency Counter     FC1001 Frequency handheld radio frequency test equipment. Design with light weight and easy to operate features. Specification Frequency Range: 10 MHz – 3 GHz Weight: ...
Sample/Wholesale
Price
Shipping
Carrier
Buy it Now
1 pcs sample
199 USD
/pcs
49 USD
DHL/UPS 7-10days

pcs
USD
/pcs
USD
Airmail 25days

Product Description

Taiwan Shijun ACECO FC1001 Handheld Portable Frequency Counter

FC1001

 

 

FC1001 Frequency handheld radio frequency test equipment. Design with light weight and easy to operate features.

Specification

Frequency Range: 10 MHz – 3 GHz
Weight: 210 g
Dimensions: 80 mm x 68 mm wide x 31 mm long
Impedance: 50 Ohms (BNC connector)
Shell: black aluminum enclosure
Power Supply: 4 AA 600 mAH NiCd battery containing
Charger: 9 VDC, 300 mA
Time base: the PPM typ. At room temperature

Feature

8 LCD display.
100 Hz resolution.
Temporary keys.
Low power consumption 6 hours NiCd batteries.
Attached telescopic antenna (144 MHz / 460 MHz) and charger.

Operating

Power Switch Power Switch: The power is turned on there will be two seconds the LCD display test.
2. Hold Button temporary keys: temporary and display in easy to read.
Calibration adjustment: FC1001 10 the PPM correction time base; the adjustment mouth in “CAL” at the semi-fixed variable capacitor to adjust the frequency counters base. The time base is factory adjusted to a rigorous test, so unless absolutely necessary and have a precisely known signal frequency, please do not be adjusted freely.
Notice tips

(1) battery

FC1001 Frequency of the power of the device is rechargeable NiCd batteries, can be used for several hours in the case of the battery is fully charged; using the supplied charger when charging, the charging time takes about 12-16 hours. In order to maintain battery life, occasionally run out of battery and then fully charged, will be able to prevent the memory effect to extend the battery life. NiCd batteries can be used for several years under normal circumstances; but it is recommended to use a year later, to view the battery is tainted fluid or corrosion, replace the battery immediately if found in order to avoid irreparable damage.

(2) the signal input

The input signal must not exceed the allowed strength!
Frequency Counters installed antenna may appear to some unknown frequency, this is because the machine itself is the signal gain and it will read some of the weaker signal, once the signal reaches the normal standard, the signal strength and frequency stable display. LED each flash represents a sampling period, the longer is the higher the resolution.

(3) antenna selection

The telescopic antenna is commonly used in antenna, it covers more bands such as HF, VHF and UHF. Adjust the antenna length when used with the test frequency will have a better frequency response, antenna length and the test frequency is inversely proportional.

(4) test distance

Surroundings from all over the RF signal, resulting in the total frequency to read the value of uncertainty, the effects of factors such as: transmission power, signal strength, antenna matching, the barrier material or a different subject position are likely to impact the following measured the approximate distance of each source.

Source distance (meters)

Wireless phones 0.3
Mobile phone 3-20
Civilian radio walkie-talkie 2-8
VHF radio walkie-talkie 3-30
UHF radio walkie-talkie 3-30

Input sensitivity

Amplifier: 50 Ohm
Impedance: 50 Ohm VSWR less than 2:1
Bandwidth: 1 MHz – 3 GHz
Sensitivity: <0.8 mV _AT_ 100 MHz to
<6 mV @ 300 MHz
<7 mV @ 1 GHz
<100 [email protected] GHz
Maximum input: 15 dBm

 

 

Leave a Reply